cannot start journal service. reason code=aaaa

An error occurred during startup or restart processing for the journal service.

aaaa: Reason code indicating the contents of the error. (Up to four numerals)

The table below shows the reason codes and countermeasures.

S: Terminates OpenTP1 abnormally.

Countermeasure: Investigate the cause that prevents the journal service from starting or restarting according to the reason code, and take countermeasures. Then, restart OpenTP1.

Reason code	Meaning	Countermeasure	Remarks
101	Insufficient memory	Check the memory capacity.	--
103	Network failure	Recover the system from the failure and restart it.	--
405	An error is detected during definition analysis processing.	Check and correct the definition file. Then, restart the system.	Message KFCA002xx shows details of the error.
406	The jnldfsv definition command is not specified in the journal service definition. -r option is not specified.	Correct the definition and restart the system.	--
503	An error occurred during I/O processing of the status file.	Investigate the cause of the error, correct the error, and restart the system.	--
504	An error occurred while starting the journal file service process or journal command service process.
508	An error occurred while starting the checkpoint dump service process.
512	An error occurred while analyzing definitions for the checkpoint dump service.	Investigate the cause of the error, correct the error, and restart the system.	--
514	An error occurred while starting the transaction recovery journal service process.	Investigate the cause of the error, correct the error, and restart OpenTP1.	Details of the cause of error was displayed before this message.
515	An error occurred during definition analysis processing for the transaction journal recovery service.	Correct the definition according to the message that was output before this message. Then, restart OpenTP1.	--
516	Starting of internal thread in journal file management service process failed.	Examine the cause of the error, correct the cause, then restart OpenTP1.	Details of the error cause were displayed immediately before this message.
517	An error occurred in an internal file in TP1/LiNK.	Investigate the cause and proceed as indicated in the system call error message output immediately before this message. Then, restart OpenTP1.	--

Legend:

--: Not applicable