error occurred during aa...aa command processing. reason code=bb...bb

An error occurred during processing of a status service command.

aa...aa: Command name (up to 10 alphanumerics)

bb...bb: Reason code

0000000001: Information in the status file control record (STR) is incorrect.

Take action according to the previously output error message, if any, or check the arguments specified in the command. If the cause cannot be determined, save the file and then contact the OpenTP1 system administrator.

0000000002: Information in the status file control record (SHR) is incorrect.

Take action according to the previously output error message, if any, or check the arguments specified in the command. If the cause cannot be determined, save the file and then contact the OpenTP1 system administrator.

0000000003: The record length is different from the active file, or the file capacity is different between A and B systems.

Use the stsls or stsfills command to examine the record length and number of records in the status file, and then use the stsinit command to initialize the file.

0000000004: The file state is disallowed for command input.

Use the stsls or stsfills command to check the file state, correct the file state setting, and then re-execute the command.

0000000005: A basic file system error occurred.

Take action according to the previously output message or the message output by status service, if any.

0000000006: The specified file name is not included in the status service definition.

Check the arguments specified in the command.

0000000007: An inter-process communication error occurred.

Take action according to the previously output error message, if any. Correct the error and then re-execute the command.

0000000008: There is no standby file for swapping.

Prepare a standby status file.

0000000009: A swapping error occurred.

Prepare a status file and then restart OpenTP1.

0000000010: A system call error occurred.

Correct the error and then re-execute the command.

0000000011: The status service is using the status file, or another status service command is running.

Close the status file being used by the status service. Alternatively, wait for the command and status service to terminate.

0000000012: A system definition analysis error occurred.

Check the system definition.

0000000013: An initialization error for inter-process communication occurred.

Correct the error and then re-execute the command.

0000000014: The command cannot be accepted.

Re-execute the command when OpenTP1 is active.

0000000015: The data length in an RPC message is incorrect.

Contact maintenance personnel.

0000000016: The active file is specified.

Use the stsls command to examine the file state, and then check the arguments specified in the command. Alternatively, swap the status file and then re-execute the command.

0000000017: The state of the specified file has already changed.

Use the stsls command to check the file state.

0000000018: An error was detected in the file check.

Use the stsinit command to initialize the file that has an error.

S: Terminates command processing.

O: Examine the previously output error message. Remove the error and then reenter the command.