OpenTP1 Version 7 Messages
KFCA01044-I (L+S)
current logical status file aa...aa is placed in the one-system operation state. The normal system is b. Take appropriate action immediately.
- aa...aa: Current logical status file name (up to eight alphanumeric characters)
- b: Normally operating system (A or B)
- O: Specify the normally operating system in the sts_last_active_side operand in the status service definition, and then perform one of the following:
- Prepare a standby status file. Use the stsswap command to swap the current file with the standby status file.
- Use the stsinit command to initialize the error system of the current status file. Use the stsopen command to open the file and again make it available for current use.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.