cannot start transaction service. reason code=aaaa

Transaction service cannot be started because an error indicated by the reason code occurred when starting or restarting the transaction service.

aaaa: Reason code (four numerals)

The reason codes and countermeasures are listed below.

S: Terminates OpenTP1 abnormally.

Countermeasure: Take action according to the reason code and then restart OpenTP1

Reason code	Meaning	Countermeasure
0001	Insufficient process memory	Reduce the number of processes and then restart OpenTP1. If the error recurs frequently, contact maintenance personnel.
0002	Failure in reading system-RM connection definition	Contact maintenance personnel.
0010	Number of RMs beyond the defined limit
0011	Resource manager registered state is invalid	The transaction service cannot be restarted after the resource manager registered state has been changed (after the trnlnkrm command has been executed). Start OpenTP1 normally. When switching function is in use, the registered statuses of the current and standby resource managers may differ. If they differ, execute the trnlnkrm command to match the registered statuses of the current and standby resource managers, then switch the resource manager.
0012	Version mismatch	The format version of the journal, checkpoint dump, or status file used when the transaction service is restarted does not match that of the transaction executable program. Start OpenTP1 normally.
0052	File manipulation failure	Check the cause of the failure according to the reason code of the KFCA00966-E message, then take appropriate corrective action.
0060	Executing an RM-registered command.	Once RM-registered command processing terminates, restart OpenTP1.
0061	Error occurred while executing an RM-registered command.	Execute the RM-registered command. Once processing terminates, restart OpenTP1.
0100	Insufficient shared memory	Estimate the shared memory and re-set the appropriate value for the size of the statically shared memory in the system environment definition. Then, start OpenTP1.
0200	Error during start processing for definition analysis	Take action according to the previously output error message if any.
0201	Failure in analyzing transaction service definitions
0300	Communication error
0600	Failure in registering service information for name service
0601	name_port operand changed	The name_port operand in the system common definition is changed when OpenTP1 is restarted. The name_port operand must not be changed when OpenTP1 is restarted. Restart OpenTP1 with the previous by specified value, or start OpenTP1 normally.
1000	Status file read failure	Take action according to the previously output error message if any.
1001	Status file write failure
1002	Status record allocation failure
1100	Error when starting journal service
1800	Failure in starting the resource manager monitoring or recovery process
1801	Error when reporting server completion to the system manager
1802	Failure upon stopping the resource manager monitoring or recovery process
2100	Error during reserved processing for obtaining checkpoint dump
2101	Checkpoint dump write failure
2102	Checkpoint dump read failure
2200	Journal read failure
2300	Pre-online recovery processing interrupted	Check and correct the value of trn_start_recovery_watch_time, and then restart OpenTP1. If the error still occurs frequently, contact maintenance personnel.