OpenTP1 Version 7 Messages
error occurred during scheduler command processing. reason code=aa...aa, command=bb...bb
Reason code | Meaning | Countermeasures |
---|---|---|
4 | Communication error | Take countermeasures according to the error message, if any, that was output before this message. Then, reenter the command. |
5 | Program version unmatched | Check and correct the versions of the OpenTP1 libraries. Then, reenter the command. |
7 | Resident process cannot be started. | Take corrective action as follows: (1)Check and correct the number of processes specified in the prc_process_count operand in the process service definition. (2)Check and correct the number of processes for the OS. (3)Enter the dcsvstart command. |
21 | Status file access error | Shutdown or shutdown release processing has been completed. However, shutdown hold processing failed. Take countermeasures according to the error message, if any, that was output before this message. Then, reenter the command. |
22 | Number of shutdown servers/services exceeded | Shutdown or shutdown release processing has been completed. However, shutdown hold processing failed. Check the value specified for the scd_hold_recovery_count operand in the schedule service definition and increase the value. Then, restart OpenTP1. |
31 | Insufficient memory | Check and correct the size of the statically shared memory in the system environment definition, and then reenter the command. For the scdhold or scdrles command, apply one of the following countermeasures according to the operating state:
|
32 | Timeout | Take countermeasures according to the error message, if any, that was output before this message. Then, reenter the command. If it was output, decrease the system load and reenter the command. If the error recurs, contact the OpenTP1 administrator. |
33 | Definition analysis error | Take countermeasures according to the error message, if any, that was output before this message. Then, reenter the command. |
34 | Shutdown management is not allowed in service units. | A service shutdown request was issued to a server for which service shutdown management is not specified (service_hold=N) in the user service definition. If shutdown management in service units is required, check the service_hold operand in the user service definition then enter the dcsvstop and dcsvstart commands, in this order. Then, reenter the scdhold command or the scdhold or scdrles command. |
35 | The server was not placed in the shutdown state by specification of the -p option. | The specified server was not placed in the shutdown state with the -p mode. For a specification error, specify the service name correctly, then enter the scdrles command. |
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.