OpenTP1 Version 7 Messages

[Contents][Index][Back][Next]

KFCA00845-W (L+E)

server shutdown state failed to be continued. reason code=aa...aa

An error occurred while continuing the server shutdown state during system restart processing.
aa...aa: Reason code indicating the contents of error. (Up to ten numerals)
The table below shows the reason codes and countermeasures.
S: Continues processing.
O: If any server must be placed in shutdown state, use the scdhold command to place it in the shutdown state.
Countermeasure: Follow the reason code.
If the reason code is 1 or 3, the server shutdown state may not be continued correctly the next time the system is restarted. Therefore, the next time the system is restarted, specify 0 for scd_hold_recovery_count in the schedule service definition. This prevents the shutdown state from continuing.
Reason code Meaning Countermeasures
1 Status file access error Apply suitable countermeasures as indicated for the error message, if any, output immediately before this message. If the server must be held in the shutdown state, enter the dcsvstop, dcsvstart, and scdhold commands, in this order. The server is again placed in the shutdown state.
2 Shutdown information incompatibility If the server must be held in the shutdown state, enter the dcsvstop, dcsvstart, and scdhold commands, in this order, to return it to the shutdown state, since the shutdown state established in the previous online session cannot be held.
3 Insufficient process-unique memory
4 No shutdown information No action is necessary if 0 was specified for scd_hold_recovery_count of the schedule service definition in the previous online session. Otherwise, if the server must be held in the shutdown state, enter the dcsvstop, dcsvstart, and scdhold commands, in this order, to return it to the shutdown state, since the shutdown state established in the previous online session cannot be held.