OpenTP1 Version 7 Messages
cannot restart service bb...bb. server name: aa...aa. reason code=cc...cc
Reason code | Meaning | Countermeasures |
---|---|---|
1 | Invalid server name | The specified server name is invalid, or the specified server has not yet been started. For a specification error, specify the server name correctly then enter the scdrles command. |
2 | Timing error | The scheduler has not yet been started or is being terminated. Restart the system and enter the scdrles command. |
3 | Server has not yet been placed in the shutdown state. | Use the scdls command to check the status of the server. |
4 | Communication error | Apply a suitable countermeasure, as indicated for the error message, if any, output immediately before this message. Then, enter the scdrles command. |
5 | Program version mismatch | Check and correct the versions of the OpenTP1 libraries, then enter the scdrles command. |
6 | Invalid server | Since the specified server is MHP or the system server, it cannot be placed in the shutdown state. For a specification error, specify the server name correctly then enter the scdrles command. |
7 | Resident process cannot be started. | Check and correct the number of processes for the system. Then, enter the scdrles command. |
8 | Shutdown management is not allowed in service units. | A service shutdown request was issued to a server for which no service shutdown management is specified (service_hold=N) in the user service definition. If shutdown management in service units is required, check the service_hold operand of the user service definition, then enter the dcsvstop, dcsvstart, and scdrles commands, in this order. |
9 | Invalid service name | The specified service name is invalid, or the service has not yet been entered on the specified server. For a specification error, specify the service name correctly then enter the scdrles command. |
10 | Service has not yet been placed in the shutdown state. | Use the scdls command to check the status of the server. |
11 | Server has been placed in the shutdown state in -p mode. | Since the server has been placed in the shutdown state in -p mode, it cannot be restarted in service units. For a specification error, specify the service name correctly then enter the scdrles command. |
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.