OpenTP1 Version 7 Messages
cannot place service bb...bb in shutdown state. server: aa...aa, reason code=cc...cc
Reason code | Meaning | Countermeasures |
---|---|---|
1 | Invalid server name | Specified server name is invalid. Or, the specified server is not started. For a specification error, specify the server name correctly then enter the scdhold command. |
2 | Timing error | The scheduler has not been started or is being terminated. Restart the system then enter the scdhold command. |
3 | Server is already placed in the shutdown state. | Use the scdls command to check the status of the server. |
4 | Communication error | Proceed as indicated for the error message, if any, output immediately before this message. Then, enter the scdhold command. |
5 | Program version mismatch | Check and correct the versions of the OpenTP1 libraries, then enter the scdhold command. |
6 | Invalid server | The specified server is a server that cannot be held (MHP, system server, debugger-linked server, etc.). For a specification error, specify the server name correctly then enter the scdhold command. |
7 | Shutdown management is not permitted for service units. | A service shutdown request was issued to a server for which no service shutdown management was specified (service_hold=N) in the user service definition. If shutdown management in service units is required, check the service_hold operand of the user service definition then enter the dcsvstop, dcsvstart, and scdhold commands, in this order. |
8 | Invalid service name | The specified service name is invalid. Or, the service is not supported by the specified server. For a specification error, specify the service name correctly, then enter the scdhold command. |
9 | Service is already placed in the shutdown state. | Use the scdls command to check the status of the server. |
10 | Server is in preparation for termination. | The specified server cannot be held since it is in preparation for termination. For a specification error, specify the server name correctly then enter the scdhold command. |
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.