OpenTP1 Version 7 Messages
KFCA00761-E (E)
error occurred during command execution. reason code=aa...aa
- aa...aa: Error that occurred during the command
- PROTOCOL: The dcreset command is entered when OpenTP1 is in a state other than the halt state.
- S: Terminates the command with error.
- O: Remove the cause of the error, and then reenter the command. It may be necessary to enter the dcstop -f command to stop the system depending on the status of OpenTP1.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.