OpenTP1 Version 7 Messages
KFCA00715-E (C)
serious error occurred; cannot continue processing (reason code=aaa). enter dcsetup -d.
- Since serious error occurred in OpenTP1, processing cannot be continued.
- aaa: Reason codes (Up to three numerals)
- 1: Contents of /etc/inittab is invalid.
- 2: Insufficient memory
- 3, 5, 104, 105: Accessing to the status file failed.
- 4, 13, 101: Opening the status file failed.
- 6, 102: Writing on a status file failed.
- 7: The system went down three consecutive times when no value is specified in the term_watch_count definition clause in the process service definition. The system went down consecutively for the specified number of time if a value is specified in the term_watch_count definition clause.
- 8: Contents of the status file invalid.
- 9, 10, 14: Writing on a status file failed.
- 11. 15, 103: Closing the status file failed.
- 12, 16: Access error in the shared memory
- 17, 18, 19: Opening of the system standard input/output failed.
- 20: OpenTP1 system common definition is invalid.
- 21: Directory move failed.
- 500: System initialization processing during startup of OpenTP1 exceeded the period of time specified in the system_init_watch_time operand in the system environment definition. Specify a sufficient length of time for system initialization processing in the system_init_watch_time operand, and then restart the system.
- S: Stops system startup or restart processing.
- Countermeasure: Eliminate the trouble and:
- execute the dcreset command, or
- execute the dcsetup -d command. Enter n in response to the command. Then execute the dcsetup command and register OpenTP1 again.
- If the cause of the error cannot be determined, contact maintenance personnel.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.