failed to notify of starting to some OpenTP1.

There is a node that was not notified of the start of OpenTP1 when OpenTP1 was started.

S: Continues processing.

O: Execute the namunavl command (which forcibly invalidates the start notification information) with the -l option specified.

Check each node on the list output by this command to see whether OpenTP1 is running normally. If OpenTP1 is running normally on each node, and an error message was output before this message, follow the instructions given in that error message to deal with the problem.

If the cause of the error cannot be found, contact maintenance personnel.

It is also possible that, since OpenTP1 startup notifications are not being properly received by the instances of OpenTP1 running on the nodes listed by the command output, these instances of OpenTP1 are unable to send acknowledgment of the startup notification. If this is the case, you will need to execute the namunavl command on each node listed, using the -n option to specify the names of the nodes on which this message appeared.