(aa....aa: bb....bb) make sure the specified value for the cc....cc: dd....dd operand is correct. if the value is correct (matches the value calculated by using the estimation formula shown in the manual), ignore this message

For details about the message types and problem identification codes, see the explanation of the definition check command in the manual OpenTP1 System Definition.

aa....aa: Message type

bb....bb: Problem identification code

cc....cc: Name of the definition file being checked

dd....dd: Name of the operand being checked

S: Continues processing.

O: If the value specified in the operand has been calculated without using the formula or if the operand is not specified, calculate the value according to the formula and then, if necessary, change the specified value.