The user server (server name=aa....aa, service group name=bb....bb) cannot start normally. The name of the UAP shared library cc....cc or the entry point name dd....dd, both of which are specified in the "service" line of the user service definition, is invalid. (cause=ee....ee, maintenance information=ff....ff)

aa....aa: Server name (up to 8 alphanumeric characters)

bb....bb: Service group name (up to 31 alphanumeric characters)

cc....cc: UAP shared library name that caused the error (pass name of up to 255 characters)

If the cause of the error is MEMORY, ******** is displayed.

dd....dd: Entry point name that caused the error (up to 31 alphanumeric characters)

If the cause of the error is MEMORY, ******** is displayed.

ee....ee: Cause of the error

MEMORY: Memory was insufficient.

ENVIRONMENT VARIABLE: The environment variable name specified for the UAP shared library name is invalid.

LIBRARY: An attempt to read the specified UAP shared library has failed.

ENTRY POINT: An attempt to acquire the specified entry point has failed.

ff....ff: Maintenance information

S: Causes dc_rpc_mainloop issued by the indicated server to return an error.

O: Take action according to the cause of the error.

MEMORY: Insufficient memory. Correct the problem and then restart the user server.

ENVIRONMENT VARIABLE: Invalid environment variable name specified for the UAP shared library name. Check and correct the environment variable name.

LIBRARY: Make sure that the specified UAP shared library name is correct. Alternatively, make sure that the UAP shared library has been created correctly.

ENTRY POINT: Make sure that the specified entry point name is correct. Alternatively, make sure that the UAP shared library has been created correctly.