This section gives the syntax and other information of the following OpenTP1 remote procedure call functions which are used for client-server communication.

• dc_rpc_call - Request a remote service
• dc_rpc_call_to - Invoke a remote service with a communication destination specified
• DCRPC_BINDTBL_SET, DCRPC_DIRECT_SCHEDULE - Create the DCRPC_BINDING_TBL structure
• dc_rpc_close - Terminate an application program
• dc_rpc_cltsend - Report data to CUP unidirectionally
• dc_rpc_discard_further_replies - Reject the receiving of processing results
• dc_rpc_discard_specific_reply - Reject acceptance of particular processing results
• dc_rpc_get_callers_address - Acquire the node address of a client UAP
• dc_rpc_get_error_descriptor - Acquire the descriptor of an asynchronous response-type RPC request which has encountered an error
• dc_rpc_get_gateway_address - Acquire the node address of a gateway
• dc_rpc_get_service_prio - Reference the schedule priority of a service request
• dc_rpc_get_watch_time - Reference the service response waiting inter - val
• dc_rpc_mainloop - Start an SPP service
• dc_rpc_open - Start an application program
• dc_rpc_poll_any_replies - Receive processing results in asynchronous mode
• dc_rpc_service_retry - Retry a service function
• dc_rpc_set_service_prio - Set a schedule priority of a service request
• dc_rpc_set_watch_time - Update a service response waiting interval

The functions for remote procedure call (dc_rpc_~) can be used in UAPs of both TP1/Server Base and TP1/LiNK.