OpenTP1 Version 7 System Definition
scdmulti (Specify multi-scheduler facility)
Format
scdmulti [-g multi-scheduler-group-name] |
Function
Specifies information about the multi-scheduler that the user server uses in the OpenTP1 system using the multi-scheduler facility.
To use the multi-scheduler facility, the following definition command and operand must be specified with this definition command:
RPC receiving side: scdmulti definition command of multi-scheduler service definition
RPC sending side: multi_schedule operand of user service definition
Option
-g multi-scheduler-group-name~<1-8 character identifier> <<scdmltgp>>
This option specifies the name of the multi-scheduler group that the user server uses.
You must specify the same name as the multi-scheduler group name specified in the -g option of the scdmulti definition command in the scheduler service definition. If you specify a name other than the multi-scheduler group name specified in the -g option of the scdmulti definition command in the scheduler service definition, the system cancels starting the user server.
If the -g option of the scdmulti definition command is not specified in both of the user service definition and the user service default definition, scdmltgp is used as the multi-scheduler group name. Therefore, do not use scdmltgp as a multi-scheduler group name.
Note
For requesting a service using the multi-scheduler facility from TP1/Client, see the manual OpenTP1 TP1/Client User's Guide TP1/Client/W, TP1/Client/P.
You can use this definition command when TP1/Extension 1 is already installed. If TP1/Extension 1 is not installed, the operation of this definition command cannot be assured.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.