OpenTP1 Version 7 System Definition
dcmarea (Specify multinode area or subarea node identifier)
Format
{{dcmarea{-m multinode-area-identifier|-g multinode-subarea-identifier} -w node-identifier[,node-identifier]...}} |
Function
The dcmarea command defines the configuration of OpenTP1 nodes that belong to the same multinode area or subarea.
The following operations cannot be done during an online session:
Command arguments
-m multinode-area-identifier~<1-8 character identifier>
Specify the multinode area identifier.
-g multinode-subarea-identifier~<1-8 character identifier>
Specify the multinode subarea identifier.
-w node-identifier[,node-identifier]~<4-character identifier>
Specify the node identifier of an OpenTP1 node that belongs to a multinode area or subarea. It must be a node identifier specified in the system common definition of each OpenTP1 node.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.