set format

[set watch_time=maximum-response-wait-time]

Command format

None

The interval service definition defines the execution environment for the interval timer function to be provided for each system server.

watch_time=maximum-response-waiting-time~<unsigned integer> ((0-65535)) (Unit: seconds)

Specify the maximum waiting time between sending a service request and receipt of a response when communicating between processes by RPC.

OpenTP1 may suspend termination processing for the length of time specified in this operand. Therefore, if you specify a large value, the termination processing of OpenTP1 may take some time.

If no response is received within the specified time, RPC returns a transmission timeout error.

If 0 is specified, the system is to wait for a response. When you specify 0, OpenTP1 may not terminate.

If this operand is omitted, the value specified with the watch_time operand of the system common definition is assumed.

Use the default of the watch_time operand of the system common definition for this operand.

We recommend that you do not change the operand unless special tuning is necessary.

If a value that is much greater or smaller than the default of the watch_time operand of the system common definition is specified, a failure may occur causing OpenTP1 to go down.

None